Which can be connected to amplifier sound at allĪ Schmitt trigger circuit shows two distinct signal input levels for turning the circuit ON and OFF.The difference between the Von and Voff voltages called hysteris Schmitt triggers are useful in conbverting slowly rising waveforms into fast rising ones and in relay like application. from the signal that is adapted to go to the leg 2 (inverting amplifier signal to a phase) of IC1 and will expand the output of Pin 6 through a signal output from C8. The VR1 is adjusted – reduce the growth of low-frequency (BASS) and VR2 is increasing – rate of growth of the frequency High (TREBLE). Q1 is the e-limit circuit fault Peter Low Power Amplifier stand out in E via C2 to the region to adjust the bass – treble. To bias the pin B of Q1 and R3 are limited to flow properly. The audio input is entered through the C1 coupling to the input signal to the Q1 growth signal by R1 and R2 divide the voltage. The power supply circuit is used from 12-24 volt and Shine Power consumption is 10 mA. This helps the smooth bass voice circuit and a rate increase – reduction of the signal at 18 dB.
0 Comments
Leave a Reply. |